210 TAMPED FILL

From MDOT Policy Manual
Revision as of 15:47, 3 April 2017 by Bgilardi (talk | contribs)

Jump to: navigation, search
210.01 DESCRIPTION.
Compact the embankment and backfill materials by means of mechanical tampers or vibratory compactors. Use this method of compaction wherever materials cannot be adequately compacted by other approved methods.
210.02 MATERIALS.
Section 916.
210.03 CONSTRUCTION.
After approval has been given by the EngineerAny person designated by the Administrator or the procurement officer, acting directly or through his duly authorized representative, such representative acting within the scope of the particular duties assigned to him or of the authority given him., place approved material in horizontal layers not exceeding 6 in. loose depth over the entire area. Tamp and uniformly compact the material using mechanical tampers or vibratory compactors. Refer to 204.03.04 for moisture and compaction.
When backfilling around abutments, retaining walls, culverts, utilities, or other structures, prevent any wedging action against the structure. When placing backfill against existing slopes, excavate benches or steps. Place the backfill in horizontal layers as described above and wide enough that there is a horizontal berm of thoroughly compacted material behind the structure at all times for a distance at least equal to the height of the structure remaining to be backfilled, except insofar as undisturbed material protrudes into this space. Tamping may be required over additional widths when the material cannot be adequately compacted by other methods. When installing structures below subgrade in embankments, place the tamped fill to a depth of 1 ft over the top of the structure. In excavation sections, extend the tamped fill to the surface of the finished earthwork.
210.04 MEASUREMENT AND PAYMENT.
Compacting embankments and backfills by mechanical tampers or vibratory compactors will not be measured but the cost will be incidental to the pertinent items specified in the Contract DocumentsThe written agreement executed between an Administration and the successful bidder, covering the performance of the work and furnishing of labor, equipment and materials, by which the Contractor is bound to perform the work and furnish the labor, equipment and materials, and by which the Administration is obligated to compensate him therefore at the mutually established and accepted rate or price. The Contract Documents shall include the Invitation for Bids, Notice to Contractors, Instructions to Bidders, Proposal, Contract Forms and Bonds, General Provisions, Specifications, Supplemental Specifications, all Special Provisions, all Technical Provisions, all Plans and Notices to Proceed, also any written Change Orders and Supplemental Agreements that are required to complete the construction of the work in an acceptable manner, including authorized extension thereof.